The aim was to keep the original visual effect. It would have been easy only to remove the original contact breaker and to replace it with the sensor, but in most cases the rotor bearing is very bad and should be overhauled.

front bearing shield	mounted bearing shield
rear bearing shield..	..with mounted pickup printed circuit board
shaft
LUCAS N1-Magneto

Since the rotor has no function anymore, it can also be replaced by a new shaft. The ignition voltage will now be generated by an external ignition coil and there will be the only disadvantage of the system: it is a battery needed, because the microcontroller in the digital ignition box needs a reasonably stable DC voltage.     

The rotor is thus replaced by an axis that is also kept completely new.

Fully assembled, the connecting lead of the pickup is led through the original ignition connector.